Question for the Pros

2003-09-15T07:33:00-04:00

I am using a suction device for pulling clear fluid through the jets of a lexmark style cartridges, and I need to know what is a safe range for setting my air pressure. I am currently running the suction at about 25 PSI I am concerned about getting the suction to high where it will damage the jet plate on the bottom of the cartridge. I am drawing the suction from the bottom of the cartridge, so in otherwords the fluid is passing from the cartridge tank down through the jets. Please email me with any suggestions: kent@wallyssupermarkets.com Thanks, Kent

Tonernews.com, September 15, 2003. USA

This topic has 0 replies, 1 voice, and was last updated 11 years, 3 months ago by Anonymous.

Viewing 1 post (of 1 total)

Author

Posts
#4091

Anonymous
Inactive

I am using a suction device for pulling clear fluid through the jets of a lexmark style cartridges, and I need to know what is a safe range for setting my air pressure.

I am currently running the suction at about 25 PSI

I am concerned about getting the suction to high where it will damage the jet plate on the bottom of the cartridge.

I am drawing the suction from the bottom of the cartridge, so in otherwords the fluid is passing from the cartridge tank down through the jets.

Please email me with any suggestions: kent@wallyssupermarkets.com

Thanks,

Kent
Author

September 15, 2003 at 7:33 AM

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

The information on this site has been included in good faith for general informational purposes only. It is not intended to amount to advice on which you should rely, and we give no representation, warranty, or guarantee, whether express or implied as to its accuracy or completeness. You must obtain professional or specialist advice before taking, or refraining from, any action based on the content on our site.